全国服务热线 0531-88985250


您所在的位置:首页 - 新闻资讯 - 新闻资讯 -


作者: admin    来源:http://www.laobingguandao.com  时间:2019-07-15    人气:
  GTA and LB welding processes are used to weld double-layer steel strip inner bellows. The welding fixture requires welding torch, laser beam focusing device and inclination of joint to vertical plane about 30 degrees. Therefore, the arc or beam penetrates the welded joint at a smaller angle. The main problem here is to ensure that the workpiece is fully exposed to the welding fixture to achieve the required minimum penetration.
  Joints must be at least 4.548 mm higher than fixtures when welded at all locations. However, too high a clamp height also makes it difficult to maintain contact between the stainless steel plates of the components. The fixture must be adjusted several times. Because of the size deviation of each part in this study, this problem can not be completely solved. Neither of the two welding parameters can be adjusted.
  Round off to fully compensate for size deviation. Therefore, there is little difference in depth between the two welding processes at different parts of the same weld. The data in Table I are obtained by transverse measurements based on cross sections cut in the correct direction within the} 5 interval.
  为了减小内焊缝的焊接变形,PA焊接系统采用脉冲焊接电流。PA焊接夹具和焊枪定位符合GTA maximus设备。但是,对PA焊接工艺的评估要晚得多,此时各部件的尺寸波动较小,并且对波纹管的夹具进行了调整,达到了佳状态,所以这些焊缝的焊接深度是稳定一致的。
  In order to reduce the welding distortion of the internal weld, the pulsed welding current is used in PA welding system. PA welding fixture and torch positioning conform to GTA maximus equipment. However, the assessment of PA welding process is much later. At this time, the size fluctuation of each component is small, and the clamp of bellows is adjusted to reach the optimal state, so the welding depth of these welds is stable and consistent.
  The air pipe filled with compressed gas is inserted into the double-walled steel bellows and connected with the bellows through air holes. Then expand one end of the exhaust pipe. The bell mouth is arranged on the inflatable eye. A spring-loaded device is installed on the buoy to enable it
  The bell head compresses the air vent to ensure that the position of the air vent does not move during welding. Firstly, the first weld and the air hole are welded on the bellows, then the second weld is welded, and the air hole and the air hole are welded on the air hole. The impermeability requirement of pipe weld casting is high, but the penetration requirement of eye plate weld O is complete.
  If you have double-button PVC pipe product requirements or anything you want to know, you can consult: click on the website http://www.laobingguandao.com

Copyright © 2016.山东老兵管道设备有限公司.All rights reserved 电话:15589946191 0531-88985250 网址:http://www.laobingguandao.com/ 地址:山东省济南市临港经济开发区   
山东老兵管道专注:pvc缠绕管,双扣聚氯乙烯缠绕管,钢带增强波纹管,双平壁钢塑复合缠绕管,塑钢缠绕管。 鲁ICP备16003217号-2
手机站二维码 微信扫一扫
咨询热线hotline 0531-88985250